|
Assembly
This is one point
the Barnett Revolution stands out: you do need
any screw to assemble the riser-limbs to the
stock. Just slide the cables in the stock slot,
slide the string over the flight rail engage the
lower harpoons onto the stock pins and pull the
foot stirrup forward until it stops and the
retaining mechanism engages that’s it , done! .
It takes more to
describe than to do… .
The Barnett
Revolution AVi features this quick detach
mechanism that allows the hunter and shooter
alike to safely transport the crossbow with the
front riser subassembly removed and just a few
seconds (15-20 actually) set up the crossbow
ready to shoot. Keep in mind that in certain
countries it is also mandatory to transport the
crossbow unassembled.
The foot stirrup is
partially covered in rubber so that it will not
slip and will be easier on your hand when you
use it as a lever to mount the front section
onto the stock (see video)-
The scope base is
integral part of the trigger-safety box
therefore it is enough to slide the rings onto
the weaver rail and mount the scope.
A side note here:
Barnett is using the smaller standard rail here
regular rings here will not fit (7/8" Weaver),
you will need the smaller 3/8" rings.
|
